Saturday, 14 November 2026

Modified Galileo Pendulum Wave vs. Pendulums on a Loose Platform

 

This follows on Four practical uses of AI here with a fifth cracking one: translate a physics experiment seen on sciencetoall.org YouTube Short here into code, in order to try a variant to it below. There are more such examples here early in the blog - at top right here is this blog's origin - and here is my AI primer. As with all my AI-assisted posts here, my text is in italics.

This experiment compares two versions of a pendulum-wave system:

  • Top model: a modified Galileo pendulum wave, with pendulums of different lengths hanging from a fixed support.
  • Bottom model: the same pendulums mounted on a loose, movable platform, allowing weak mechanical coupling between them.

The purpose is to test whether the pendulums eventually synchronize like slightly out-of-step metronomes on a loosely fixed beam, or whether the lack of a movable support prevents synchronization.

Physical idea

A pendulum’s period depends mainly on its length:

T = 2π√(L/g)

In the pendulum wave, the strings are deliberately cut to different lengths. The longest pendulum completes the fewest oscillations during the cycle, while the shortest completes the most. After the chosen cycle time, every pendulum has completed a whole number of swings, so all the bobs briefly return to their starting phase.

For the original 48-pendulum circle, the design uses oscillation counts from 51 to 60 over 2 minutes and 14 seconds (134 seconds). At 134 seconds, all pendulums have completed an integer number of oscillations, so they briefly line up again.

Fixed support: uncoupled pendulums

In the top simulation, the pendulums hang from a effectively rigid support. Their swings do not significantly move the support, so there is little or no feedback from one pendulum to another.

The pendulums therefore behave approximately as independent oscillators. They create travelling-wave, standing-wave, and apparently disordered patterns, but they do not spontaneously settle into a common rhythm.

The sciencetoall.org YouTube Short is here.

Loose platform: coupled pendulums

In the bottom simulation, the pendulums hang from a light platform that can move slightly sideways. When a pendulum swings, it pushes on the platform. The platform then moves and feeds that motion back to the other pendulums.

This is the same basic mechanism that allows metronomes on a movable surface to synchronize. Over time, the pendulums may entrain to a shared rhythm, often swinging in phase or in anti-phase depending on the setup.

Hannah Fry sync'ing metronome demonstration is here


Python model

The Colab model uses a simplified two-dimensional coupled-pendulum model. Each pendulum is affected by gravity, damping, and the horizontal acceleration of the shared platform. The platform is affected by the horizontal reaction forces from all swinging bobs.

The main parameters are:

  • Number of pendulums: N
  • Pendulum lengths: lengths
  • Bob mass: bob_mass
  • Platform mass: platform_mass
  • Pendulum damping: bob_damping
  • Platform damping: platform_damping
  • Initial release angle: theta0

A lighter platform produces stronger coupling. Lower damping allows the motion to persist longer. Pendulums with similar natural frequencies are more likely to synchronize.

The Python code is posted on Google Colab here - scroll to the bottom to see the animation shown below - here is its top screen grab:

click to enlarge

What I observed

Fixed-support result: the pendulums remained largely independent. Their phase differences produced the expected pendulum-wave patterns, but they did not gradually synchronize.

Loose-platform result: the platform began to move as the pendulums swung. With suitable platform mass and damping, the pendulums showed a tendency to synchronize.

Here is the video file created by Google Colab linear model. The full circular analog model is here.

Animation: Pendulum wave comparison: fixed support versus loose movable platform (full here).

Conclusion

The pendulum wave does not synchronize because its support is effectively fixed. The pendulums are uncoupled, so their relative phases are determined by their different string lengths.

When the same pendulums are placed on a sufficiently light, low-friction movable platform, their motion can become coupled. The platform acts as a mechanical connection between the pendulums, allowing them to influence one another and potentially synchronize.

In short: a solid support prevents synchronization; a movable support makes it possible.


Experiment modelled in Google Colab using Python, NumPy, SciPy, and Matplotlib.

No comments:

Post a Comment